● Energy, pulse width, frequency and focus can be adjusted within a wide range to achieve different welding effects.
● Ceramic reflector used in the laser pump chamber is imported, which is corrosion resistant, high temperature resistant, high electrical/optical conversion.
● World-leading automatic light shielding system is employed to remove harmful lighting on eyes during operation.
● 24-hour continuous operation, with stable operating performance,
● Free of maintenance within 10000 hours.
● Personalized design in compliance with ergonomics principles.
Main Structure & Maintenance
The whole system is composed of:
A. Laser Generator B. Laser Power C. Optical System
D. Control system E. Cooling system
Operation
Step 1) Start the chiller and wait for 1-2 minutes until the water temperature reaches the target value you set. Normally 25 Celsius Degrees.
Step 2) Turn on the air switch behind the welder
Step 3) Twist the key switch to start laser welder
Step 4) Press “OK” button on control panel, the word OPEN turns into CLOSE. Set parameters correctly based on the type of material and the result of test shooting. Sometimes it relies more on operator’s experience.
Step 5) Turn on the LED light and adjust the position of cover gas nozzle before welding so that your work piece can be prevented from quick oxidation. You can also change all parameters by the joystick inside the welding chamber or stop welding immediately by the emergency button.
Step 6) Now you are free to weld.
step 7) When you finish welding, move the dash on CLOSE, press OK button, turn off the key switch, turn off the chiller and cut the total power. Finally, please open the protective cover and clean the dusts in the welding chamber. We strongly suggest you to do this at least once a week.
